This is Needle Specimen                          All View       Able to controle Azimuth rotation

Allowing complete 360 degree rotation!! The new HATA-Holder, operates individually with respect to the X-axis tilt mechanism of the stage.     Includes its own high performance tilt mechanism allowing complete 360 degrees rotation! At eucentric height the x-axis tilt mechanism of the microscope stage has a minor displacement at      small tilt angles.   However the higher the tilt angles become the larger the image displacement of the stage. The new HATA-Holder has built-in X axis-tilt mechanism which can be used with an offset in steps of 15 degrees. For example, a tilt series with +/- 60 degrees may be acquired first with an HATA-Holder offset of 0 degrees,     then adjust the  HATA-Holder offset to 120 degrees. Another series may be acquired and by repeating     this one more time a total of 360  degrees is possible. Additional flexibility is possible by using only the most reliable tilt range of the stage itself. With data acquired by tilting 360 degrees, naturally the result is a more accurate and reliable reconstruction.     There is no lack of information which is a true improvement compared to traditional tomography data. Both sides of the specimen can be easily observed.  Using this holder, turning a specimen upside down (180 degrees) is possible at any time.     Without removing the specimen holder from the microscope or removing a grid from the holder itself the field      of view can be reversed for easier orientation of a crystal or other tasks. After a 180 degrees tilt angle adjustment the optical axis with respect to the tilt-rotation axis has minimum     displacement Fine tuning of the sample position is sufficient.     The azimuth of the object of interest stays the same after a 180 degrees tilt operation.     Further it allows new ways of operation such as two sided image comparison.     Concerning tomography three dimension reconstruction operations this holder brings great advantage since     inclination  image information can be acquired continuously. New HATA Holder - 360 More Spec result Item Name : HATA-Holder - 360 More (Set of HATA Holder -360 More with Index Dock System)      Item No : 911 0624 5300 Applicable instrument : JEOL TEM　 except UHR type of Pole Piece TEM Needle CFS (Comprtments to Fasten Specimen) 　　　　　　　　　　　　Note:　This Needle CFS is already able to use for HATA Holder for FEI Tecnai and Titan TEMs. Maximum X tilt range 360 Degree(with needle CFS)     Note: The new HATA-Holder has built-in X axis-tilt mechanism which can be used withan offset in steps of 15 degrees. Maximum Y tilt range +/-7.50 degrees.      (Fully motorized control) Maximum Azimuth rotation range +/-5.00 degrees.      (Controlled by off line Index Dock System)